7-61
Cisco TelePresence System Release 1.6 Administration Guide
OL-13676-04
Chapter 7 Troubleshooting the CTS 1300
Managing Hardware Setup
Figure 7-57
Adjusting the Camera Zoom
Step 7
Tighten the thumbscrews for the zoom and focus rings.
Step 8
Click Hide Camera Targets.
Step 9
Click the Setup button, then click the Auto Adjust button.
The auto adjust procedure completes. This procedure takes several seconds.
Note
If there is insufficient light, the auto adjust procedure terminates; in this case, add more light to the room
and repeat the auto adjust procedure.
Step 10
Click Done to complete the procedure.
Calibrating the Left Camera
To adjust the zoom and perform initial focus adjustment for the left camera, complete the steps in the
following procedure.
Note
If you logged out of the GUI, you must re-select the correct table type after you log in; otherwise, you
could configure your system for the incorrect table type. To select the correct table type, complete
Step 5
in the
“Positioning the Table and Starting the Calibration Procedure” section on page 7-51
.
Step 1
Move the large camera target 86 inches (218 cm) from the display, and 18 inches (46 cm) overhanging
the table on the left side. See
Figure 7-54
for the location of the left target.
Step 2
Position the target to that it is parallel with the wall.
Step 3
In the Cisco TelePresence administrative GUI, click the Left radio button.
Step 4
Click Show Camera Target.
206357
