6-16
Cisco TelePresence System Release 1.5 Administrator Guide
OL-13676-04
Chapter 6 Troubleshooting the CTS 1100
Managing Hardware Setup
Note
The red and green bars do not have to be exactly the same length; get them as close as you can.
When the bars are roughly the same length, the camera is focused.
e.
Without moving the focus ring, tighten its thumbscrew.
Step 7
Click Done to complete the procedure.
Saving Your Settings
When you have configured all your settings, follow these steps:
Step 1
Click Apply to register new or modified settings.
Step 2
Click Reset to restore the original settings.
For more information about testing and troubleshooting the CTS 1000, see the
Setting Up the Camera
section in the
Cisco TelePresence 1100 Assembly, Use & Care, and Field-Replacement Unit Guide
.
Attaching the Camera Lens and Hood
To attach the camera lens and hood, follow these steps:
Step 1
Place the foam lens cover onto the camera lens, as shown in
Figure 6-13
.
Figure 6-13
Attaching the Foam Lens Cover to the Camera Lens
Step 2
Replace the camera cover onto the camera cluster, then tighten the cover release screws to secure the
cover to the camera, as shown in
Figure 6-14
.
206625
7
