UPPER THREADING
24
Using the Spool Stand
The included spool stand is useful when using
thread on spools with a large diameter (cross-
wound thread). This spool stand can hold two
spools of thread.
• Be sure to use a spool cap that is slightly larger
than the spool.
If the spool cap that is used is smaller or much
larger than the spool, the thread may catch and
embroidering performance may suffer.
• When using thread on a thin spool, place the
included spool felt on the spool pin, place the
thread spool on the spool pin so that the center
of the spool is aligned with the hole at the center
of the spool felt, and then insert the spool cap
onto the spool pin.
a
Spool felt
• When using thread on a cone spool, use the
spool holder. When using cone shaped thread
spool with other than cotton thread, it is not
necessary to use spool caps.
a
Spool holder
• Depending on the size of spool or the amount of
thread remaining, choose the appropriate sized
spool cap (large or medium). Spool cap (small)
cannot be used with the spool cap base.
a
Spool cap
b
Spool cap base
a
Attach the spool stand to the machine.
Memo
• Refer to the Instruction and Reference Guide
(Sewing) to assemble the spool stand.
• Refer to page 19 to wind the bobbin when
using the spool stand.
a
b
Summary of Contents for Solaris VISION BLSA3
