ABB FSO-21, User Manual

Page: 404 / 540

404 Parameters
200.73 SMS limit positive Sets the positive speed limit for the SMS
function.
Note : This parameter is used only in version
2 of the SMS function.
0.0 rpm
0.0…35880.0 rpm Speed
200.101 SAR0 version Shows the version of the SAR0 function. Version 1
Version 1 Version 1.
200.102 SAR0 ramp time to
zero
Sets the target time for the SAR0 ramp
(used in the SSE function).
Target time = Time in which the drive
decelerates the motor from speed
200.202
SAR speed scaling to zero.
1 ms
1…1,800,000 ms Time
200.111 SAR1 version Shows the version of the SAR1 function. Version 1
Version 1 Version 1.
200.112 SAR1 ramp time to
zero
Sets the target time for the SAR1 ramp
(used in the SS1 and SLS functions).
Target time = Time in which the drive
decelerates the motor from speed
200.202
SAR speed scaling to zero.
Note : With value 0 ms , the drive (parameter
23.23 Emergency stop time ) defines the safe
stop ramp. The FSO module monitors the
actual ramp using SAR1 parameters (ramp
monitoring) or parameter
SS1.14 SS1-t
delay for STO (time monitoring).
1 ms
0…1,800,000 ms Time.
200.201 Drive general
settings version
Shows the version of the drive general
safety settings (includes parameters
200.202 , 200.222 , 200.223 and 200.254 ).
Version 1
Version 1 Version 1.
200.202 SAR speed scaling Sets a speed value that the FSO module
uses as a reference point in ramp time
calculations.
See section
Ramp monitoring on page 57 .
1500 rpm
0…35880 rpm Speed
200.222 Safety bus type Sets the type of the safety fieldbus (if used).
Note : To activate the safety fieldbus, you
must also set parameter SBUSGEN. 01
SBUS activity and version to value Version
1 .
Not used
Not used The safety fieldbus is not used.
PROFIsafe PROFIsafe
Index Name/Value Description Factory
default