ABB FSO-21, User Manual

Page: 18 / 540

18 Introduction to the manual
Compatible products
Check the compatibility of the earlier versions with your local ABB representative.
See also section
FSO module version handling on page 37 .

ACS880 drives and option modules
• ACS880 series without “No FSO support” sticker
• ACS880 primary control program: version 2.21 or later
• FSE-31 pulse encoder interface module: revision D or later
• FENA-21 Ethernet adapter module: version 3.05 or later
• FPNO-21 PROFINET fieldbus adapter module: version 1.00 or later
Application control programs
FSO-21 behavior is independent from application control program, thus all application
control programs are supported by FSO-21. Example applications:
• Machinery control program v2.40 or later
• Crane control program v2.1 or later
• Tower crane control program v1.0 or later
• Winch control program v1.0 or later
• Winder control program v1.10 or later
• PCP/ESP control program (+N5200) v1.1 or later
• PCP/ESP control program SynRM v1.1.1.0 or later
• Spinning control program v1.0 or later
• Rod pump control program v1.0 or later
Note: If you want to use the possibility to switch the motor speed feedback between
encoder and estimate, ACS880 primary control program version 2.51 (or later) and
FSE-31 revision F (or later) are required. See section
Motor speed feedback on page
44 .

DCS880 drives and option modules
• DCS880 drive modules
• DCS880 firmware, version 2.07 or later
• FSE-31 pulse encoder interface module: revision D or later
• FENA-21 Ethernet adapter module: version 3.11 or later
• FPNO-21 PROFINET fieldbus adapter module: version 1.00 or later
Note that there are fundamental differences how a DCS880 drive operates when
compared to an ACS880 drive. This leads to the following limitations:
• STO takes 500 ms to be achieved in DCS880 drives. Further, a secondary
switching device (i.e. AC-breaker, medium voltage breaker or DC-breaker) must