YASKAWA SIEMENS CNC Series, Руководство по обслуживанию, Руководство для служащего по обслуживанию

Страница: 172 / 373

Drive Parameter Screen
11.4.2 Troubleshooting
11-12
11.4.2 Troubleshooting
When the screen of abnormal state is displayed, use the following procedure.
1. Check if the drive power supply is powered on.
2. Press the [Back (F1)] key to go back to the last screen.
3. Activate NCK-Reset.
4. After NCK-Reset has completed, wait for the drive diagnosis screen to display OK
showing the Read/Write function is available.
5. The drive parameter screen displays.
11.4.3 Indication of parameter whose value can not be read
The parameter whose value can not be read or which is failed to read is displayed with "#"
for the parameter setting value (see
④
of the section 11.1.2 Screen configuration).
11.4.4 Error message display
This is a list of error messages in relation to this function.
Error message Content
ACC-file Mapping failed ! Mapping of ACC file has failed.
No drive is available ! The drive is not connected. Or the drive is not powered
on.
Please wait,
until all drives are available. This indication is displayed until all drives recover the
normal communication.
There exists one or more drives which is abnormal in
communication. This message remains on the screen
until all the drives recover the normal communication.
Write Error ! Read-only: Parameter No. Rewrite operation is executed for an unrewitable
parameter.
Write Error ! Can not be changed in
current access level: Parameter No. Rewrite operation is executed for a parameter which is
unrewritable in the current protection level.
Write Error ! Range over Minimum =<
value =< Maximum: Parameter No. Setting value is below or above the range permitted for
the parameter setting.
Write Error: Parameter No Parameter
Name
There occurs a Write Error other than those above.
Search term not found. The Search was executed but the target item has not
been found.