Suzuki 2000 Grand Vitara SQ416, Руководство по обслуживанию

Страница: 474 / 729

YH4
GRAND
VITARA
1. Cylinder head
2. Water outlet pipe
1. Cylinder head gasket
2. Cylinder block
3. Knock pin 4. Crankshaft pulley side
5. Flywheel side
1. Crankshaft pulley side
2. Flywheel side
1. Crankshaft pulley side
2. Flywheel side
1. Crankshaft pulley side
2. Flywheel side
3. Bolt (M6)
“TOP”
ENGINE MECHANICAL (J20 ENGINE) 6A4-55
9) Install intake manifold, injectors, exhaust manifold, water outlet
pipe and water outlet cap to cylinder head.
NOTE:
When installing water outlet pipe, apply sealant to the
thread of the bolt shown in figure.
“A”: Sealant 99000-31110
INSTALLATION
1) Clean mating surface of cylinder head and cylinder block.
Remove oil, old gasket and dust from mating surface.
2) Install knock pins to cylinder block.
3) Install new cylinder head gasket to cylinder block.
“TOP” mark provided on gasket comes to crankshaft pulley side,
facing up (toward cylinder head side).
4) Install cylinder head to cylinder block.
Apply engine oil to cylinder head bolts and tighten them gradual-
ly as follows.
(1) Tighten all bolts to 53 N
.
m (5.3 kg-m, 38.5 lb-ft) according to
numerical order in figure.
(2) In the same manner as in (1), tighten them to 84 N
.
m (8.4
kg-m, 61.0 lb-ft).
(3) Loosen all bolts until tightening torque is reduced to 0 in the
illustrated order.
(4) Tighten all bolts to 53 N
.
m (5.3 kg-m, 38.5 lb-ft) according to
numerical order in figure.
(5) In the same manner as in (4) again, tighten them to specified
torque.
Tightening Torque
(a): 105 N
.
m (10.5 kg-m, 76.0 lb-ft)
(b): 11 N
.
m ( 1.1 kg-m, 8.0 lb-ft)
NOTE:
Be sure to tighten M6 bolt after securing the other bolt.