Suzuki 2000 Grand Vitara SQ416, Руководство по обслуживанию

Страница: 417 / 729

YH4
GRAND
VITARA
ENGINE MECHANICAL (H25 ENGINE) 6A2-93
2, (a)
3, (b)
1. Lower crankcase
2. Bolt (10 mm thread diameter)
3. Bolt (8 mm thread diameter)
4. Long bolt (8 mm thread diameter)
1. Rear oil seal
1. Fly wheel bolt
6) Install crankcase to cylinder block. Apply oil to crankcase bolts be-
fore installing them. Tighten crankcase bolts, following sequence
in figure. Tighten crankcase bolts to specified torque.
NOTE:
Tighten 10 mm thread diameter bolts first (following the order
shown in figure), then tighten 8 mm thread diameter bolts.
Tightening Torque
(a): 60 N
.
m (6.0 kg-m, 43.5 lb-ft)
(b): 27 N
.
m (2.7 kg-m, 19.5 lb-ft)
NOTE:
After tightening crankcase bolts, check to be sure that crank-
shaft rotates smoothly when turned by hand.
7) Using special tools (Oil seal installer and oil seal guide), install
rear oil seal.
Special Tool
(B): 09911-97810
(C): 09911-97710
8) Install flywheel (M / T vehicle) or drive plate (A / T vehicle). Us-
ing special tool, lock flywheel or drive plate, and tighten fly-
wheel or drive plate bolts applied with sealant to specification.
“A”: Sealant 1215 99000-31110
Special Tool
(A): 09924-17810
Tightening Torque
(c): 70 N
.
m (7.0 kg-m, 50.5 lb-ft)
9) Install oil pump, pistons and connecting rods as previously out-
lined.
10) Install oil pump strainer and oil pan.
11) Install cylinder heads assembly to cylinder block as previously
outlined.
12) Install crankshaft oil pump sprocket, timing chain sprocket, oil
pump chain, timing chain, timing chain cover, crankshaft pulley,
water pump pulley, etc., as previously outlined.
13) Install clutch to flywheel (for M / T vehicle). For clutch installa-
tion, refer to Section 7C1.
14) Install engine assembly to vehicle as previously outlined.