Suzuki 2000 Grand Vitara SQ416, Руководство по обслуживанию

Страница: 672 / 729

YH4
GRAND
VITARA
1. Brush
2. Brush spring
3. Brush holder
1. Rear bracket
2. Brush holder screws
1. Over-running clutch
2. Pinion stop ring
3. Snap ring
4. Gear shaft
1. Shaft ass’y
2. Lever
6G-10 CRANKING SYSTEM
REASSEMBLY
CAUTION:
Washing, adjusting and disassembling of shock absorber
(clutch plate) are not allowed.
New oilless bearing have been lubricated when they are
supplied as spare parts. DO NOT wash with grease dis-
solving solvent nor lubricate them with other lubricant.
1) Inspect component parts (Refer to page 6G-12) and replace
with new ones as necessary.
2) Apply grease (Refer to page 6G-3).
3) Install armature to yoke.
4) Install brushes and brush springs to brush holder.
5) Install brush holder to armature while pushing 4 brushes out-
ward.
6) Install rear bush and then rear bracket cap.
7) Install rear bracket.
8) Tighten brush holder screws.
9) Install over-running clutch assembly to gear shaft, using care
for installing direction of pinion stop ring.
10) Insert shaft ass’y into front housing with lever positioned as
shown left figure.