Suzuki 2000 Grand Vitara SQ416, Руководство по обслуживанию

Страница: 151 / 729

YH4
GRAND
VITARA
6-1-40 ENGINE (H25 ENGINE)
TERMINAL CIRCUIT NORMAL VOLTAGE CONDITION
E61-21, 22 ——— ——— ———
Immobilizer indicator lamp (vehicle
0 – 1 V Ignition switch ON
E61-23
(
without monitor connector)
10 – 14 V Engine running
E61-23
Duty output terminal (vehicle with
monitor connector)
0 – 1 V Ignition switch ON
E61-24 Data link connector (5 V) 4 – 6 V Ignition switch ON
E61-25 Data link connector (12 V) 10 – 14 V Ignition switch ON
10 – 14 V Ignition switch ON
E61-26 Power steering pressure switch
0 – 1 V
With engine running at idle speed, turning
steering wheel to the right or left as far as it stops
E61 27 A / C cut signal (if equipped)
0 – 1 V A / C is not operating
E61-27 A / C cut signal (if equipped)
10 – 14 V A / C is operating
E61 28 A / C signal (if equipped)
10 – 14 V
Ignition switch ON, A / C switch or heater blower
switch OFF
E61-28 A / C signal (if equipped)
0 – 1.5 V
Ignition switch ON, A / C switch ON and heater blower
switch ON
E61 29 Lighting switch
0 – 1 V Ignition switch ON, lighting switch OFF
E61-29 Lighting switch
10 – 14 V Ignition switch ON, lighting switch ON
E61-30
Diag. switch terminal (vehicle with
monitor connector)
10 – 14 V Ignition switch ON
E61 31 Stop lamp switch (A / T VEHICLE)
0 – 1 V
Brake pedal released (switch OFF),
Ignition switch ON
E61-31 Stop lamp switch (A / T VEHICLE)
10 – 14 V
Brake pedal depressed (switch ON), Ignition switch
ON
E61-32
CO adjusting resistor ground
(if equipped)
——— ———
E61-33
Power source for CO adjusting
resistor (if equipped)
4.75 – 5.25 V Ignition switch ON
E61 34 Malfunction indicator lamp
0 – 2.5 V Ignition switch ON, engine stops
E61-34 Malfunction indicator lamp
10 – 14 V Engine running
E61-35 Power source for back up 10 – 14 V Ignition switch ON and OFF
C51-3-1 Vehicle speed sensor
Deflects between
0 and over 4 V
Ignition switch ON, Rear right tire turned slowly with
rear left tire locked
C51-3-2
Crankshaft position (CKP) sensor
(if equipped)
——— ———
C51-3-3
Crankshaft position (CKP) sensor
(if equipped)
——— ———
C51-3-4
Heated oxygen sensor
(Bank 1 – Sensor 1) (if equipped)
Deflects between
over and under
0.5 V
While engine running at 2,000 r / min.
for 1 min. or longer after warmed up
10 – 14 V Ignition switch ON
C51-3-5
Heater of HO2S
(Bank 2 – Sensor 1) (if equipped)
Deflects between
0 – 1 V and
10 – 14 V
At specified idle speed after engine warmed up
10 – 14 V Ignition switch ON
C51-3-6
Heater of HO2S
(Bank 1 – Sensor 1) (if equipped)
Deflects between
0 – 1 V and
10 – 14 V
At specified idle speed after engine warmed up
C51-3-7 ——— ——— ———
C51-3-8 Intake air temp. sensor 2.2 – 3.0 V
Ignition switch ON, Sensor ambient temp.:
20
_
C, 68
_
F