Suzuki 2000 Grand Vitara SQ416, Руководство по обслуживанию

Страница: 94 / 729

YH4
GRAND
VITARA
6-90 ENGINE DIAGNOSIS (G16 / J20 ENGINES)
TROUBLESHOOTING (DTC P0500 / DTC No.24)
STEP ACTION YES NO
1 Was “ENGINE DIAG. FLOW TABLE” performed? Go to Step 2. Go to “ENGINE
DIAG. FLOW
TABLE”.
2 Does speedometer indicate vehicle speed? Faulty “Bl / Y” wire or
poor C51-2-25
connection.
If wire and connec-
tion are OK, intermit-
tent trouble or faulty
ECM (PCM).
Check for intermittent
referring to “Intermit-
tent and Poor Con-
nection” in Section
0A. Go to Step 3.
3 VSS Power Supply Voltage Check:
1) With ignition switch OFF, remove VSS coupler.
2) With ignition switch ON leaving engine OFF, check
voltage between C20-3 and C20-2 terminal of VSS
coupler.
Is voltage 10 – 14 V?
Go to Step 4. “B / Bl” or “B / Y” wire
open /short.
4 VSS Signal Harness Check:
1) With ignition switch ON leaving engine OFF, check
voltage between C20-1 and C20-2 terminal of VSS
coupler.
Is voltage 4 V or more?
Go to Step 5. Go to Step 6.
5 VSS Visual Inspection:
1) Remove VSS referring to “TRANSFER” section.
2) Check VSS drive and driven gears for damage and
excessive wear.
Are they in good condition?
Poor VSS connection
or VSS malfunction.
If connection is OK,
substitute a known-
good VSS and
recheck. Replace VSS.
6 Speedometer Circuit Check:
1) With ignition switch OFF, disconnect G11 coupler
from combination meter.
2) With ignition switch ON leaving engine OFF, check
voltage between C20-1 and C20-2 terminal of VSS
coupler.
Is voltage 4 V or more?
Substitute a known-
good combination
meter and recheck. “Bl / Y” wire open /
short or faulty ECM
(PCM).
If wire and connec-
tion are OK, substi-
tute a known-good
ECM (PCM) and
recheck.