Suzuki 2000 Grand Vitara SQ416, Руководство по обслуживанию

Страница: 462 / 729

YH4
GRAND
VITARA
1. Intake camshaft
2. Exhaust camshaft
3. Pin installation position
I: Intake side
E: Exhaust side
Position from timing chain side
Timing chain side
1. Stud bolt
2. Timing chain guide
ENGINE MECHANICAL (J20 ENGINE) 6A4-43
5) Install camshaft housing pins as shown in figure.
6) Apply sealant “A” to exhaust camshaft end housing sealing
surface area as shown in figure.
“A”: Sealant 99000-31150
7) Check position of camshaft housings.
Embossed marks are provided on each camshaft housing, in-
dicating position and direction for installation. Install housings
as indicated by these marks.
8) After applying oil to housing bolts, tighten them temporarily
first. Then tighten them by following sequence as indicated in
figure. Tighten a little at a time and evenly among bolts and re-
peat tightening sequence two or three times before they are
tightened to specified torque.
Tightening Torque
(a): 11 N
.
m (1.1 kg-m, 8.0 lb-ft)
9) Install CMP sensor.
Refer to Section 6F2 for CMP sensor installation.
10) Install 2nd timing chain.
Refer to item “2ND TIMING CHAIN AND CHAIN TENSIONER”
in this section for installation.
11) Install timing chain cover.
Refer to item “TIMING CHAIN COVER” in this section for instal-
lation.
12) Install cylinder head cover. Refer to item “CYLINDER HEAD
COVER” in this section for installation.
13) Install oil pan and oil pump strainer.
Refer to item “OIL PAN AND OIL PUMP STRAINER” in this
section for installation.
14) Install cooling system and other parts.
15) Refill cooling system with coolant, front differential with gear oil,
engine with engine oil and power steering system with speci-
fied fluid.
16) Verify that there is no coolant leakage, power steering fluid
leakage, exhaust gas leakage and oil leakage at each connec-
tion.
17) Check ignition timing and adjust as necessary, referring to Sec-
tion 6F2.