Suzuki 2000 Grand Vitara SQ416, Руководство по обслуживанию

Страница: 330 / 729

YH4
GRAND
VITARA
For RH steering vehicle
For LH steering vehicle
6A2-6 ENGINE MECHANICAL (H25 ENGINE)
OIL PRESSURE CHECK
NOTE:
Prior to checking oil pressure, check the followings.
Oil level in oil pan
If oil level is low, add oil up to Full level hole on oil level
gauge.
Oil quality
If oil is discolored, or deteriorated, change it.
For particular oil to be used, refer to Section 0B.
Oil leaks
If leak is found, repair it.
1) Remove oil pressure switch from cylinder block.
2) Install special tool (Oil pressure gauge) to vacated threaded
hole.
For LH steering vehicle, use oil pressure gauge (special tool (A))
with special tool (B) instead of the steel adaptor supplied in spe-
cial tool (A).
Special Tool
(A): 09915-77310
(B): 09915-76510
3) Start engine and warm it up to normal operating temperature.
4) After warming up, raise engine speed to 4,000 r / min. (rpm) and
measure oil pressure.
Oil pressure specification:
390 – 470 kPa (3.9 – 4.7 kg / cm
2
, 55.5 – 66.8 psi) at
4,000 r / min (rpm)
5) After checking oil pressure, stop engine and remove oil pressure
gauge.
6) Before reinstalling oil pressure switch, be sure to wrap its screw
threads with sealing tape and tighten switch to specified torque.
Tightening Torque
(a): 14 N
.
m (1.4 kg-m, 10.0 lb-ft)
NOTE:
If sealing tape edge is bulged out from screw threads of
switch, cut it off.
7) Start engine and check oil pressure switch for oil leakage.