YH4
GRAND
VITARA
ENGINE DIAGNOSIS (G16 / J20 ENGINES)
6-69
TROUBLESHOOTING (DTC P0300/P0301/P0302/P0303/P0304)
STEP
ACTION
YES
NO
1
Was “ENGINE DIAG. FLOW TABLE” performed?
Go to Step 2.
Go to “ENGINE
DIAG. FLOW
TABLE”.
2
Ignition System Inspection:
1) Check spark plug and ignition spark of cylinder
where misfire occurs, referring to “IGNITION
SYSTEM” section.
Is it in good condition?
Go to Step 3.
Faulty ignition coil,
wire harness, or other
system parts.
3
Fuel Injector Circuit Inspection:
1) Using sound scope, check each injector
operating sound at engine cranking or idling.
Do all injectors make operating sound?
Go to Step 4.
Check coupler
connection and wire
harness of injector not
making operating
sound and injector
itself.
If OK, substitute a
known-good ECM
(PCM) and recheck.
4
Fuel Pressure Inspection:
1) Check fuel pressure referring to TABLE B-3 in
this section.
Is check result satisfactory?
Go to Step 5.
Repair or replace.
5
Fuel Injector Inspection:
1) Check fuel injector(s) referring to “ENGINE AND
EMISSION CONTROL SYSTEM” section.
Is check result satisfactory?
Go to Step 6.
Replace.
6
Ignition Timing Inspection:
1) Check ignition timing referring to “IGNITION
SYSTEM” section.
Is check result satisfactory?
Go to Step 7.
Adjust or check
system related parts.
7
EGR System Inspection:
1) Check EGR system referring to “ENGINE AND
EMISSION CONTROL SYSTEM” section.
Is check result satisfactory?
Go to Step 8.
Repair or replace.
8
Fuel Level Sensor Inspection:
1) Check fuel level sensor referring to DTC P0461
Diag. Flow Table.
Is check result satisfactory?
Go to Step 9.
Repair or replace.
9
Check engine mechanical parts or system which
can cause engine rough idle or poor performance.
– Engine compression (See “ENGINE
MECHANICAL” section).
– Valve lash or lash adjuster (See “ENGINE
MECHANICAL” section).
– Valve timing (Timing belt or chain installation.
See “ENGINE MECHANICAL” section).
Are they in good condition?
Check wire harness
and connection of
ECM (PCM) ground,
ignition system and
fuel injector for
intermittent open
and short.
Repair or replace.
Содержание 2000 Grand Vitara SQ416
