Suzuki 2000 Grand Vitara SQ416, Руководство по обслуживанию

Страница: 84 / 729

YH4
GRAND
VITARA
1) and 2)
Vehicle speed
km / h (mph)
6-80 ENGINE DIAGNOSIS (G16 / J20 ENGINES)
DTC DETECTING CONDITION AND TROUBLE AREA
DTC DETECTING CONDITION TROUBLE AREA
During deceleration (engine speed high with closed
throttle position) in which fuel cut is involved, difference
in intake manifold pressure between when EGR valve
is opened and when it is closed is smaller than
specified value.
(2 driving cycles detection logic)
D
EGR valve
D
EGR passage
D
Manifold absolute pressure sensor
D
ECM (PCM)
DTC CONFIRMATION PROCEDURE
WARNING:
D
When performing a road test, select a place where there is no traffic or possibility of a traffic accident
and be very careful during testing to avoid occurrence of an accident.
D
Road test should be carried out with 2 persons, a driver and a tester, on a level road.
NOTE:
Check to make sure that the following conditions are satisfied when using this DTC CONFIRMATION PRO-
CEDURE.
D
Intake air temp.: – 8
_
C, 18
_
F or higher
D
Engine coolant temp.: – 8 – 110
_
C (18 – 230
_
F)
D
Altitude (barometric pressure): 2400 m, 8000 ft or less (560 mmHg, 75 kPa or more)
1) Connect scan tool to DLC with ignition switch OFF.
2) Turn ON ignition switch and clear DTC, pending DTC and freeze frame data by using scan tool and warm up
engine completely.
3) Increase vehicle speed to 55 – 60 km / h (35 – 40 mph).
4) Keep driving above vehicle speed for 7 min. or more.
5) Increase vehicle speed to 100 – 110 km / h (60 – 70 mph).
6) Release accelerator pedal and with engine brake applied, keep vehicle coasting and then stop vehicle.
7) Check if DTC and pending DTC exists by using scan tool. If not, check if EGR system monitoring test has com-
pleted by using scan tool. If not in both of above checks (i.e., no pending DTC and EGR system monitoring test
not completed), check vehicle conditions (environmental) and repeat Steps 3) through 6).