Mitsubishi Electric fr-e700 series, Инструкция по эксплуатации

Страница: 522 / 608

CC-Link IE Field Network Basic Parameter
6 - 368
Setting the operation commands
The following program gives a forward command and middle speed command to station 1 inverter.
햲
These signals are initial values. You can change input signals using Pr. 180 to Pr. 184 "Input termi-
nal function selection". Note that some of the signals do not receive a command from the pro-
grammable controller depending on the setting.
Monitoring the output frequency
The following explains a program to read monitor functions of the inverter.
●
The following program reads the output frequency of station 1 inverter to D1.
●
Output frequency read code: H0001 (hexadecimal)
Refer to page 6-363 for the monitor codes.
For example the output frequency of 60Hz is indicated as H1770 (6000).
I003131E, I003132E
Fig. 6-179: Program example 3
I003133E
Fig. 6-180: Program example 4
(0)
SM1536 SD1536.0 SD1540.0 M0
(4)
M0 X20 Y1000
Y1003
(8) END
Check the data link status of the station 1
Forward rotation command (RY00)
Middle speed operation command (RY03)
0 0 0 0 0 0 0 0 0 0 0 0 1 0 0 1
0 b 5 1 b
0 0 0 1 Y F 0 0 1 Y
b7
Station 1
RY0F to RY00
[Run command]
Middle speed
b6: Second function selection (RT signal)
햲
b7: Terminal 4 input selection (AU signal)
햲
b8: —
b9: Output stop (terminal MRS)
햲
b10: —
b11: Inverter reset(terminal RES)
햲
Forward rotation
Run command
b0: Forward rotation command
b1: Reverse rotation command
b2: High-speed operation command (terminal RH)
햲
b3: Middle-speed operation command (terminal RM)
햲
b4: Low-speed operation command (terminal RL)
햲
b5: —
1: ON
0: OFF
RY1F to RY10
(0)
SM1536 SD1536.0 SD1540.0 M0
(4)
M0 X20
MOV H1 W100
Y100C
X100C
MOV W0 D1
(12)
M0 X20 Y1000
Y1003
(16)
END
Check the data link status of the station 1
Set monitor code (H01) of output frequency to
RWw0.
Turn on the monitor command (RY0C)
Read output frequency (RWr0) to D1 when the
monitoring (RX0C) turns on.