Mitel MIVOICE OFFICE 250, Руководство по установке и администрированию

Страница: 325 / 585

Installation
297
8. Flip the handset hanger down to the horizontal position and lock it into place. This will hold the
handset in place.
The following instructions apply to phones that have release buttons located on the bottom phone
housing. To disengage the locking mechanism in the base, push in both buttons. To lock the base
in position, release the buttons.
To wall-mount Mitel 8000 Series phones with release buttons on bottom housing:
1. Close the base completely so that it lies flat against the phone. Rivet hole 1 on the base aligns
with the rivet hole on the bottom housing of the phone.
2. Plug the four-inch line cord into the jack on the back of the phone and thread the line cord
through the wall-mount knockout on the base.
3. Insert one of the plastic rivets in rivet hole 1 on the base (see illustration above) and press it
into the rivet hole on the phone. This locks the base to the phone.
4. Test the base to verify that it is securely locked to the phone.
5.
Re-attach the metal plate to the phone base.
6. Insert the remaining plastic rivet through rivet hole 3 (as shown at
right) in the metal plate and press it firmly into rivet hole 2 in the
base. This locks the metal plate to the base.
7.
Plug the line cord into the jack on the wall-mount bracket and po -
sition the phone securely on the wall-mount bracket.
8.
Flip the handset hanger down to the horizontal position and lock it
into place. This will hold the handset in place.
Rivet Hole
Base
Rivet Hole 1
Release Buttons
Bottom Housing
(Base not shown)
Rivet Hole 2
(Used to lock metal plate to base)
(Used to lock base to bottom housing)
Rivet Hole 3
Metal Plate