Mitel MIVOICE OFFICE 250, Руководство по установке и администрированию

Страница: 554 / 585

MiVoice Office 250 Installation and Administration Guide
526
Signals and Tones
The MiVoice Office 250 provides auditory signals and tones that convey particular messages to
users. This section describes the meanings of system sounds and graphically depicts what is heard
by the user when the phone rings and what is heard over the handset during system operation.
Ringing Signals
The following table depicts the system signals and tones that are generated by the ringer or phone
speaker, as shown in Table 78 .
Call Processing Signals
Table 79 shows the signals and tones that are heard through the handset or phone speaker.
Table 78: Ringing Signals
Type of Call Signal
Outside call or recall Single long tone every 6 sec.
Intercom call, off-hook voice
announce call, or queue callback
Two short tones and a pause
(repeats for private calls and
callbacks).
NOTE: If the phone option for
different IC/CO alerting tones is
disabled, this will be the same as
the outside call signal shown
above.
Reminder message Eight short tones
Table 79: Call Processing Signals
SIGNAL ACTION
Intercom dial tone Handset lifted or Speaker or IC button
pressed.
Double tones (called
phone receives the same
signal)
Intercom call—repeats for private call or
call to non-handsfree phone; one double
tone for handsfree call.
Intercom busy signal —
slow repeating tones
Called phone or selected trunk is busy.
A repeating signal of four
fast tones and a pause
Called phone is in Do-Not-Disturb mode.
Recorder tones — fast
tones (may be four or
continuous)
Entry was not accepted, number is toll
restricted, or dialing timer expired.
(Sheet 1 of 2)