Mitel MIVOICE OFFICE 250, Руководство по установке и администрированию

Страница: 439 / 585

Private Networking
411
SMDR routing. SMDR reports for Node 1 would be printed to the backup port on Node2 and
vice versa.
• Voice Mail Messages : To correct for time zone differences when message notification is sent
from EM on one node to phones on other nodes, there is a Time Zone setting in each mailbox.
If set properly, the voice mail message envelope will indicate the time the message was received
using the mailbox’s programmed time zone.
• SMDR Buffering : The optional EM will buffer SMDR records that are sent from other nodes in
the network.
• Message Print : Each node has its own message print programming, message print output port,
and message print output port backup. There should be a message print terminal at each node
to monitor node and network performance and aid in troubleshooting. the
MiVoice Office 250
Features and Programming Guide
• If the node Message Print output port is a node, the network sends Message Print records
to the specified node.
• You cannot select a node as the message print output port backup.
• If Message Print output programming forms a loop, the system will send the output to the
node backup Message Print port. For example, if the Message Print port on Node 1 routes
to Node 2 and the Message Print port on Node 2 routes to Node 1, the configuration will
cause an infinite loop. Message Print reports for Node 1 would be printed to the backup port
on Node2 and vice versa.
• A two digit node number is inserted in front of the sequence number to indicate the node
where the message originated. The following is an example of the new message print string
format for a message that originated on node 3:
- 03 :001- 15:30 03-20 M6009 WRN EG CP Corrupted Queue Was Cleared: HISTORY
QUEUE
• Message Print will
not
route diagnostic messages that apply to another node, except during
manual Message Print requests.
• Message Print will not send messages during a startup or reset. The system will wait one
minute before starting to send messages. Startup messages will only be printed locally.
• Messages may not be printed in time sequence order on remote nodes. The order of an
incoming message print depends on how the message print was routed to the destination
node. Therefore, a message print could possibly arrive at the destination message print
node out of order.
• System OAI : System OAI Applications that support networking can be used in conjunction with
the CT Gateway/Transceiver. For detailed information about the Gateway/Transceiver, see
page 328 . The Gateway allows a single System OAI application to support a multi-node network.
Each application will require a separate Gateway.
Some System OAI applications that do not support networking will not operate properly on a
MItel system that is part of a network, even with a Gateway. This is because those applications
are not designed to track calls that cross over from node to node within a network. Those System
OAI applications can only be used on stand-alone Mitel systems that are not part of a network.