Mitel MIVOICE OFFICE 250, Руководство по установке и администрированию

Страница: 243 / 585

Installation
215
Unpacking the DEI Equipment
After all digital telephones and related devices are installed and station/device cabling has been run
or is in place, you are now ready to install the DEI chassis and modules.
To unpack the equipment and inspect the equipment chassis and all accompanying parts:
1. Check the parts against the packing slip and inspect them for damage. If any item is missing or
damaged, contact Technical Support immediately. See Table 57, “Contact Information,” on
page 370 .
2. Check all circuit module assemblies as follows:
a. Check each module to ensure there is no shipping foam or tape attached.
b. Inspect each module for shorted components.
c. Return all modules to their protective bags until they are ready to be installed in the chassis.
3. Check that the protective covers over the module bays are in place. These covers protect debris
or other foreign matter from entering the system and possibly harming the internal components.
These covers should remain in place until you are ready to install a module.
NOTICE
Electrostatic Discharge (ESD) . System modules and components are static-sensitive. Handle the
modules by the edges only and keep them in their protective bags until they are to be installed. Do not
bend or touch the component pins or subject them to a static charge. When working with the modules,
use a properly terminated anti-static wrist strap and cover the work surface with the bag that protected
the module during shipping. Any static charge—no matter how small—must be discharged from the body
before touching the modules or other components.
The warranty for this equipment does not cover
damage caused by static or mishandling. Modules or components damaged in such a manner will not be
replaced.