Mitel MIVOICE OFFICE 250, Руководство по установке и администрированию

Страница: 326 / 585

MiVoice Office 250 Installation and Administration Guide
298
Wall-Mounting Executive/Professional/Standard/Associate Digital
Telephones
To mount the phone on a wall, use an industry-standard wall-mount bracket (sometimes called a
wall jack assembly). If a wall-mount bracket is not available, use the two-screw method outlined
below:
1. Remove the phone baseplate from the top half of the back of the phone.
2. Rotate the baseplate 180
o
and attach it to the bottom half of the back of the phone. If a PCDPM
is already installed inside the baseplate, first open the phone and reroute the PCDPM-to-keyset
interface cable through the knockout in the bottom half of the phone. See Figure 13 on
page 356
.
3. Using a ruler, mark the location of the phone mounting holes on the wall. The centers of the two
perpendicular mounting holes on the back of the phone are four inches apart.
4. Drive a screw into the center of each mounting hole marking. Allow the head of the screw to
protrude approximately ¼ inch.
5. To hold the handset in place while the phone is wall-mounted, slide the reversible cradle hook
out, rotate it 180
o
, and reinsert it as shown below.
6. Position the phone mounting holes over the screws and slide the phone into position on the
wall. If necessary, adjust the screws to ensure the phone is held firmly in place.
Adjusting the Baseplate on Executive/Professional/Standard/Associate Digi -
tal Telephones
The Professional, Associate, and Basic phones have adjustable baseplates that allow users to set
the angle of the phone.
To change the baseplate position:
1. Gently press on one edge of the baseplate and lift it off of the phone.
2. If you have a PCDPM installed, route the cables so that they will be between the baseplate and
the bottom of the phone.
3. Position the baseplate over one of the three sets of holes and snap it into place. The curved
edge should be toward the top of the keyset.