Mitel MIVOICE OFFICE 250, Руководство по установке и администрированию

Страница: 290 / 585

MiVoice Office 250 Installation and Administration Guide
262
To configure the Mitel 52xx/53xx phones automatically:
1. Make sure the MiVoice Office 250 is up and running, and then make sure you have done the
following (if applicable):
• Configured the Mitel 52xx/53xx phones in DB Programming (refer to the
MiVoice Office 250
Features and Programming Guide
, for details). Also, read “Hardware Revision Identification“
on page 265 .
If the phone is pointing to the MiVoice Office 250 and the phone has not been configured
in DB Programming, the display appears to be downloading but nothing is actually
happening. You must configure the phones in DB Programming before configuring the
phone.
• Check that the following DHCP options have been configured. Keep in mind that some
DHCP servers, typically found in SOHO routers, do not support the ability for custom options.
You can include all parameters within one option or you can configure several options.
•
Setting a single option
: Using the Windows-provide
Option 43 or Option 125
, type the
following ASCII character string, after clicking once in the ASCII column:
id:ipphone.mitel.com;sw_tftp=
<MiVoice Office 250 base server IP address>
;call_s -
rv=
<MiVoice Office 250 base server IP
address>
;vlan=<
VLANID
>;l2p=<
value
>;dscp=<
value
>
Note that the entries in italics need to be replaced with those that are network-specific.
For example, if the MiVoice Office 250 is using IP address 10.0.0.1; and the vLAN ID =
100; 12p = 6; and dscp = 46, then the typed ASCII character string would be as follows:
id:ipphone.mitel.com;sw_tftp=10.0.0.1;call_srv=10.0.0.1;vlan=100;l2p=6;dscp=46
•
Setting several options
:

Options 128 and 129
: Option 128 provides the TFTP address, and Option 129 provides
call control information. Both should be set to the IP address of the Base Server.
 Option 130
: Type the text string “MITEL IP PHONE” (case sensitive).

Mitel also has two additional Options to consider if putting these phones on a separate
VLAN:

Option 132
: Type the integer and set to “VLAN for IP Phone.

Option 133
: Type the integer and set to “Priority on Vlan.” If using option 132, you must
use option 133.
• See the troubleshooting section on page 261 for any phone issues.
2. (Optional) You can connect a PC to the PC port on the back of the phone. If desired, thread the
PC cable through the slot on the back of the installed base unit, as shown for the LAN cable in
Figure 3 on
page 259
.
3. Continue to the Programming chapter in the
MiVoice Office 250 Features and Programming
Guide
, for information on programming phones or other features in this release.