Match state : match //Indicates that the capability profile bound
to the ONU is
//consistent with the actual capability
of the ONU.
...//The rest of the response information is omitted.
huawei(config-if-gpon-0/3)#
quit
If the ONU state fails, the ONU fails to be in the up state, or the ONU does not match,
check the ONU state by referring to the above-mentioned descriptions.
l
If
Control flag
is
deactive
, run the
ont activate
command in the GPON port mode to
activate the ONU.
l
If the ONU fails to be in the up state, that is,
Run state
is
offline
, the physical line may
be broken or the optical transceiver may be damaged. You need to check both the
material and the line.
l
If the ONU state fails, that is,
Config state
is
failed
, the ONU capability set outmatches
the actual ONU capabilities. In this case, run the
display ont failed-configuration
command in the diagnosis mode to check the failed configuration item and the failure
cause. Then, rectify the fault according to actual conditions.
NOTE
If an ONT supports only four queues, the values of 4-7 of the priority-queue parameter in the gem add
command are invalid. After configuration recovers, Config state will be failed.
6.
Configure the management channel from the OLT to the ONU.
NOTE
Only when the OLT remotely manages the ONU through SNMP, the management channel needs to be
configured. When the OLT remotely manages the ONU through OMCI, the management channel need
not be configured.
a.
Configure the inband management VLAN and IP address of the OLT.
To log in to the ONU through Telnet and configure the ONU from the OLT, you must
configure the inband management VLANs and IP addresses of the OLT and the ONU
on the OLT.
Create management VLAN 8 and add upstream port 0/0/0 to it. Configure the inband
management IP address to 192.168.50.20/24.
huawei(config)#
vlan 8 smart
huawei(config)#
port vlan 8 0/19 0
huawei(config)#
interface vlanif 8
huawei(config-if-vlanif8)#
ip address 192.168.50.20 24
huawei(config-if-vlanif8)#
quit
b.
Configure the inband management VLAN and IP address of the ONU.
Configure the static IP address of the ONU to 192.168.50.2/24 and the management
VLAN ID to 8 (the same as the management VLAN of the OLT).
huawei(config)#
interface gpon 0/3
huawei(config-if-gpon-0/3)#
ont ipconfig 1 1 ip-address 192.168.50.2 mask
255.255.255.0 manage-vlan 8
c.
Configure an inband management service port.
Configure the management service port ID to 0, management VLAN ID to 8, GEM
port ID to 0, and CVLAN ID to 8. The rate of the inband service port on the OLT is
not limited. Therefore, use traffic profile 6 (default). To limit the rate of the service
port, run the
traffic table ip
command to add a traffic profile and bind it to the service
port.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
17 Electrical Service Configuration
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1802
