2 --- -/ -/ - --- --- --- ---
3 --- -/ -/ - --- --- --- ---
4 --- -/ -/ - --- --- --- ---
5 --- -/ -/ - --- --- --- ---
6 --- -/ -/ - --- --- --- ---
7 --- -/ -/ - --- --- --- ---
8 --- -/ -/ - --- --- --- ---
9 --- -/ -/ - --- --- --- ---
-----------------------------------------------------------------
huawei(config)#
display clock source system
-----------------------------------------------------------------------
Index Board Source Clk-type State Priority QL Selected
-----------------------------------------------------------------------
0 H801GICK 0/19/ 0 --- Normal 0 --- YES
1 H801GICK 0/19/ 1 --- Normal 1 --- ---
-----------------------------------------------------------------------
l
Configure the ONU-side clock (the clock is connected to the base station by using GE
port to implement time synchronization).
This configuration is applicable to time synchronization in the base station where
synchronous base station technologies (TDS-CDMA/CDMA2000/LTE is a representative)
are adopted. The base station must provide ETH ports and support 1588v2 packets.
1.
Add a system clock source (frequency synchronization).
The 1588v2 clock is issued to the ONU through the optical path of the PON port,
implementing the clock synchronization between the OLT and the ONU.
a.
Run the
clock source
command to add the 1588v2 clock source as the system
clock source.
huawei(config)#
clock source 0 0/0/1
b.
Run the
clock priority
command to configure the priority of the 1588v2 clock
source.
huawei(config)#
clock priority system 0
2.
Configure the 1588v2 time source (time synchronization).
a.
Run the
ptp enable
command to enable the 1588v2 function.
huawei(config)#
ptp enable
b.
Run the
ptp source
command to add the 1588v2 clock source as the system clock
source.
huawei(config)#
ptp source 0 0/0/1
c.
Run the
ptp priority
command to configure the priority of the 1588v2 clock
source.
huawei(config)#
ptp priority 0
3.
Run the
ptp port enable
command to enable the 1588v2 function on the Ethernet port
to transmit 1588v2 packets on the specified port.
huawei(config)#
ptp port 0/3/1 enable
4.
Query the configuration and status of the 1588v2 clock source and system clock
source.
–
Run the
display ptp source
command to query the status of the 1588v2 clock
source.
–
Run the
display clock source
command to query the configuration and status of
the system clock source.
huawei(config)#
display ptp source
---------------------------------------------------------------------
Index Type Source State Priority Selected Lock state
---------------------------------------------------------------------
0 1588 0/0/1 Normal 0 --- successful
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
14 FTTM Configuration (Base Station Access)
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1397
