Control flag : active //Indicates that the ONU is
activated.
Run state : online //Indicates that the ONU already goes online
normally.
Config state : normal //Indicates that the configuration status
of the ONU is normal.
...//The rest of the response information is omitted.
If the ONU state fails, the ONU fails to be in the up state, or the ONU does not match,
check the ONU state by referring to the above-mentioned descriptions.
l
If
Control flag
is
deactive
, run the
ont activate
command in the GPON port mode to
activate the ONU.
l
If the ONU fails to be in the up state, that is,
Run state
is
offline
, the physical line may
be broken or the optical transceiver may be damaged. You need to check both the
material and the line.
l
If the ONU state fails, that is,
Config state
is
failed
, the ONU capability set outmatches
the actual ONU capabilities. In this case, run the
display ont failed-configuration
command in the diagnosis mode to check the failed configuration item and the failure
cause. Then, rectify the fault according to actual conditions.
NOTE
If an ONT supports only four queues, the values of 4-7 of the priority-queue parameter in the gem add
command are invalid. After configuration recovers, Config state will be failed.
6.
Configure the management channel from the OLT to the ONU.
NOTE
Only when the OLT remotely manages the ONU through SNMP, the management channel needs to be
configured. When the OLT remotely manages the ONU through OMCI, the management channel need
not be configured.
a.
Configure the inband management VLAN and IP address of the OLT.
To log in to the ONU through Telnet and configure the ONU from the OLT, you must
configure the inband management VLANs and IP addresses of the OLT and the ONU
on the OLT.
Create management VLAN 8, and configure the inband management IP address to
192.168.50.20/24.
huawei(config-if-gpon-0/3)#
quit
huawei(config)#
vlan 8 smart
huawei(config)#
port vlan 8 0/19 0
huawei(config)#
interface vlanif 8
huawei(config-if-vlanif8)#
ip address 192.168.50.20 24
huawei(config-if-vlanif8)#
quit
b.
Configure the inband management VLAN and IP address of the ONU.
Configure the static IP address of the ONU to 192.168.50.2/24 and the management
VLAN ID to 8 (the same as the management VLAN of the OLT).
huawei(config)#
interface gpon 0/3
huawei(config-if-gpon-0/3)#
ont ipconfig 1 1 ip-address 192.168.50.2 mask
255.255.255.0 manage-vlan 8
c.
Configure an inband management service port.
Configure the management service port ID to 0, management VLAN ID to 8, GEM
port ID to 0, and customer VLAN (CVLAN) ID to 8. The rate of the inband service
port on the OLT is not limited. Therefore, use traffic profile 6 (default). To limit the
rate of the service port, run the
traffic table ip
command to add a traffic profile and
bind it to the service port.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
17 Electrical Service Configuration
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1822
