l
Configuration of the service flow:
–
ID of the management service flow: 0
–
ID of the management VLAN: 8
–
ID of the GPON encapsulation mode (GEM) port: 0
–
ID of the customer VLAN (C-VLAN): 8
l
Device where upstream and downstream packet rates are limited: D-CMTS
In this case, use the default traffic profile with ID 6, which does not limit the rate of a
service flow. To limit packet rates, run the
traffic table ip
command to create a traffic
profile and bind it to the service flow.
huawei(config)#
service-port 0 vlan 8 gpon 0/3/1 ont 1 gemport 0 multi-service
user-vlan 8 rx-cttr 6 tx-cttr 6
NOTE
l
On IPv6 networks, run the
dhcpv6-option permit-forwarding port 0/3/0 enable
command to enable
DHCPv6 Option forwarding on a specified port.
l
If CPEs support IPv6 prefixes, run the
security bind-route-nd enable
command to enable associated
routes and neighbor entries. Then, the OLT automatically generates the routing and neighbor entries
of a DHCPv6 user based on the user information recorded when the user goes online. This prevents
the need of manually configuring static routes and sending neighbor discovery (ND) packets to the
user side, thereby improving system security.
Step 2
Check whether the management channel between the OLT and the D-CMTS is available.
l
Run the
ping 192.168.50.1
command on the OLT to check whether the D-CMTS can
communicate with the OLT. If the OLT can receive Internet Control Message Protocol
(ICMP) ECHO-REPLY packets sent from the D-CMTS, the D-CMTS is connected to the
OLT.
l
Run the
telnet
command on the OLT to remotely log in to the ONU from the OLT to perform
the configuration. The user name is root and the password is mduadmin.
----End
16.4.1.9 Configuring a Service Channel Between an OLT and a D-CMTS
Data Plan
Item
Data
High-speed Internet (HSI), VoD,
broadband TV (BTV), or dynamic
PacketCable service
ID of the OLT VLAN (transparently transmitting D-
CMTS packet tags): 100
ID of the D-CMTS VLAN: 100
ID of the common open policy service (COPS)
connection VLAN: 1000
Procedure
l
Configure a channel for a home service.
1.
Configure service flows to receive and transparently transmit D-CMTS packets.
The following configurations are used as an example to configure service flows:
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
16 OptiCable D-CMTS Configuration (MA5633 Working as
a Standalone NE)
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1751