huawei(config)#
service-port 0 vlan 8 gpon 0/3/1 ont 1 gemport 0 multi-
service
user-vlan 8 rx-cttr 6 tx-cttr 6
7.
Confirm that the management channel between the OLT and the ONU is available.
l
On the OLT, run the
ping 192.168.50.2
command to check the connectivity to the ONU.
The ICMP ECHO-REPLY packet from the ONU should be received.
l
You can run the
telnet 192.168.50.2
command to telnet to the ONU and then configure
the ONU.
8.
Configure a GPON type C protection group.
Set OLT_A as the active OLT and OLT_B as the standby OLT. Configure a protection
group on both OLT_A and OLT_B. Set the group member status on OLT_A to work and
the group member status on OLT_B to protect. After the setting, when the active OLT is
faulty, the system automatically switches to the standby OLT, ensuring service running.
NOTE
l
For a working port, the protect group is enabled by default and you do not need to enable it any more.
For a protect port, the protect group is disabled by default. Run the
protect-group enable
command
to enable the protect group.
l
Run the
protect-group member port 0/3/1 ont 1 role protect
command on OLT_B to specify the
member type in a protect group to protect. Other configurations are the same as that on OLT_A.
huawei(config)#
protect-group 0 protect-target gpon-uni-ont workmode dual-
parenting
huawei(protect-group-0)#
protect-group member port 0/3/1 ont 1 role work
huawei(protect-group-0)#
protect-group enable
//Determine whether to run this
command based on the type of the member type in a protect group on the port
huawei(protect-group-0)#
quit
9.
Create a service port.
Configure the site information service port ID to 1, SVLAN ID to 200, GEM port ID to 1,
and CVLAN ID to 100, and configure the GOOSE packets service port ID to 2, SVLAN
ID to 101, GEM port ID to 2, and CVLAN ID to 101. Rate limitation for upstream and
downstream packets is performed on the ONU instead of on the OLT.
The same port is used for transmitting the site information about the electrical power system
and GOOSE packets. Therefore, the 802.1p priority of each service needs to be set. The
priority of the site information about the electrical power system is lower than that of
GOOSE packets. Set the traffic profile index of the site information about the electrical
power system to 20 and the priority to 1; set the traffic profile index of GOOSE packets to
21 and the priority to 6.
The CVLAN must be the same as the upstream VLAN of the ONU.
huawei(config)#
traffic table ip index 20 cir off priority 1 priority-policy
local-Setting
Create traffic descriptor record
successfully
------------------------------------------------
TD Index :
20
TD Name : ip-traffic-
table_20
Priority :
1
Copy Priority :
-
Mapping Index :
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
17 Electrical Service Configuration
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1839
