DHCP option: The DHCP option for IPv4 is DHCPv4 option 82 and for IPv6 is DHCPv6 option
18/37.
The DHCPv6 option18 and option37 functions can be enabled or disabled at two levels. This
function takes effect only when it is enabled at both levels.
1.
Global level: Run the
dhcpv6 option enable
command in global config mode.
2.
VLAN level: Run the
dhcpv6 option enable
command in VLAN service profile mode.
Device Management Data Planning
Device management data planning includes the management channel and IP address planning.
The management channel for IPv6 and IPv4 services are the same.
Planning
Device or Service Solution Introduction
Management
channel
OLT
The device management uses single-tagged VLANs
on the entire network.
ONU
The device management uses single-tagged VLANs
on the entire network.
IP address
planning
Device
management
IPv4 private network IP addresses are still used as
management IP addresses of the OLT and MDU
devices.
Internet
l
IPv4 address: A PC obtains the IPv4 address
from the BRAS using PPPoE or DHCP. If IPoE
dial-up is used, the static address can be
configured for the PC.
–
The BRAS can allocate a public network IP
address to a PC for Internet access.
–
The BRAS can allocate a private network
address to a PC. The private network address
is translated to the public network address by
CGN (NAT44).
l
IPv6 address: A PC obtains the IPv6 address
from the BRAS using PPPoE, SLAAC, or
DHCPv6. If IPoE dial-up is used, the static
address can be configured for the PC.
IPTV service
The IPTV service is not provisioned in this scenario.
VoIP service
The IPv4 protocol is still used. An ONU functions
as the DHCP client to obtain the IP address using
DHCP.
QoS Planning
The E2E QoS planning includes the flow classification, marking/scheduling policy, traffic
monitoring, and DBA policy.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
19 IPv6 Configuration
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1886
