1.
In global config mode, run the
security anti-ipspoofing enable
command to
enable IP address anti-spoofing at the global level.
2.
In VLAN service profile mode, run the
security anti-ipspoofing enable
command to enable IP address anti-spoofing at the VLAN level.
3.
Run the
security anti-ipspoofing service-port serviceport-id
enable
command
to enable IP address anti-spoofing at the service port level.
l
Configure service security.
–
Enable Dynamic Host Configuration Protocol (DHCP) Option 82 on both the OLT
and ONUs. This configuration is recommended for the DHCP-based Internet access
service.
1.
Enable DHCP Option 82 on both the OLT and ONUs.
DHCP Option 82 can be enabled or disabled at four levels: global, port, VLAN,
and service port levels. This function takes effect only after it is enabled at the
four levels. Among the four levels, DHCP Option 82 is disabled only at the global
level by default.
–
The global level: In global config mode, run the
dhcp option82
command to
enable DHCP Option 82 at the global level.
When you run this command, select the
enable
,
forward
, or
rebuild
parameter based on site requirements. The three parameters can all enable
DHCP Option 82 but provide different packet processing policies on the OLT.
For details, see the
dhcp option82
command.
–
The port level: In global config mode, run the
dhcp option82 port
or
dhcp
option82 board
command to enable DHCP Option 82 at the port level.
–
The VLAN level:
a.
In global config mode, run the
vlan service-profile
command to create
a VLAN service profile.
b.
Run the
dhcp option82 enable
command to enable DHCP Option 82 at
the VLAN level.
c.
Run the
commit
command to make the profile configuration take effect.
d.
Run the
quit
command to quit the VLAN service profile mode.
e.
Run the
vlan bind service-profile
command to bind the created VLAN
service profile to a VLAN.
–
The service port level: In global config mode, run the
dhcp option82 service-
port
command to enable DHCP Option 82 at the service port level.
2.
On the OLT, run the
dhcp-option82 permit-forwarding service-port
command
with the
enable
parameter selected, to allow ONU DHCP packets to carry Option
82 information.
–
Enable Policy Information Transfer Protocol (PITP) on both the OLT and ONUs. This
configuration is recommended for the PPPoE-based Internet access service.
1.
Enable PITP on both the OLT and ONUs.
PITP can be enabled or disabled at four levels: global, port, VLAN, and service
port levels. This function takes effect only after it is enabled at the four levels.
Among the four levels, PITP is disabled only at the global level by default.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
11 FTTB and FTTC Solution Configuration
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1011
