a.
Add an ONU.
Connect the ONU to GPON port 0/3/1. The ONU ID is 1, the SN is
48575443E6D8B541, the management mode is SNMP, and the bound line profile ID
is 10.
There are two ways to add an ONU. Select either of the two ways according to actual
conditions.
l
Add an ONU offline: If the password or SN of an ONU is obtained, you can run
the
ont add
command to add the ONU offline.
l
Automatically find an ONU: If the password or SN of an ONU is unknown, run
the port
ont-auto-find
command in the GPON mode to enable the ONU auto-find
function of the GPON port. Then, run the
ont confirm
command to confirm the
ONU.
To add an ONU offline, do as follows:
huawei(config)#
interface gpon 0/3
huawei(config-if-gpon-0/3)#
ont add 1 1 sn-auth 48575443E6D8B541 snmp ont-
lineprofile-id
10 desc MA5621_0/3/1/1_lineprofile10
To automatically find an ONU, do as follows:
huawei(config)#
interface gpon 0/3
huawei(config-if-gpon-0/3)#
port 1 ont-auto-find enable
huawei(config-if-gpon-0/3)#
display ont autofind 1
//After this command is executed, the information about all ONUs
connected to the GPON port through the optical splitter is displayed.
------------------------------------------------------------
Number : 1
F/S/P : 0/3/1
Ont SN : 48575443E6D8B541
Password :
VenderID : HWTC
Ont Version : MA5621
Ont SoftwareVersion : V800R312C00
Ont EquipmentID : SmartAX MA5621
Ont autofind time : 2012-09-10 11:20:16
------------------------------------------------------------
huawei(config-if-gpon-0/3)#
ont confirm 1 ontid 1 sn-auth 48575443E6D8B541
snmp ont-lineprofile-id
10 desc MA5621_0/3/1/1_lineprofile10
NOTE
If multiple ONUs of the same type are connected to a port and the same line profile or service profile
is bound to the ONUs, you can add ONUs in batches by confirming the auto-found ONUs in batches
to simplify the operation and increase the configuration efficiency. For example, the preceding
command can be modified as follows: huawei(config-if-gpon-0/3)#
ont confirm 1 all sn-auth snmp
ont-lineprofile-id 10 desc MA5621_0/3/1_lineprofile10
.
5.
Confirm that the ONU goes online normally.
After an ONU is added, run the
display ont info
command to query the current status of
the ONU. Ensure that
Control flag
of the ONU is
active
,
Run State
is
online
, and
Config
state
is
normal
.
huawei(config-if-gpon-0/3)#
display ont info 1 1
---------------------------------------------------------------------
F/S/P :
0/3/1
ONT-ID :
1
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
17 Electrical Service Configuration
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1821
