Item
Data
Remarks
Multicast
emulation
parameters
Multicast service flow ID: 1
MVLAN: 1000
IP address of the multicast
program: 224.1.1.10
-
Procedure
l
Verify the Internet access service using PPPoE dialup emulation.
1.
In the xPON board mode, run the
pppoe simulate start
command to start a PPPoE
dialup emulation test.
The service is functional if the test result is
success
. The following test uses GPON
as an example:
huawei(config)#
interface gpon 0/1
huawei(config-if-gpon-0/1)#
pppoe simulate start
{ portid<U><0,7> }:
0
{ ontid<U><0,127> }:
1
{ eth<K>|untagged<K>|vlanid<U><0,4095> }:
eth
{ ont-portid<U><1,8> }:
4
{ untagged<K>|vlanid<U><0,4095> }:
100
{ priority<U><0,7>|user-name<K> }:
user-name
{ username<S><Length 1-64> }:
test@huawei
{ user-password<K> }:
user-password
{ password<S><Length 1-64> }:
test
{ authentication-mode<K> }:
authentication-mode
{ protocol<E><chap,pap> }:
chap
Command:
pppoe simulate start 0 1 eth 4 100 user-name test@huawei user-
password
test authentication-mode chap
huawei(config-if-gpon-0/1)#
----------------------------------
ONT PPPoE Test Result
----------------------------------
F/S/P : 0/1/0
ONT-ID : 1
ONT ETH Port ID : 4
ONT Vlan ID : 100
Vlan Priority : -
Emluator result : Success
Session ID : 18814
User IP : 172.16.100.109
Gateway IP : 172.16.100.1
----------------------------------
l
Troubleshooting methods for the Internet access service
1.
Check whether configurations are complete on the OLT.
–
Run the
display ont info
command to query the ONU status to check whether the
ONU is registered successfully.
–
Run the
display service-port
command to check whether the Internet access
service flow is configured and whether the inner VLAN ID of the service flow is
consistent with that in the data plan.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
12 FTTO Configuration(SOHO and SME)
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1231
