interface to 10.10.10.10, which facilitates the configuration of the media and signaling IP address
pools.
huawei(config)#
vlan 20 standard
huawei(config)#
port vlan 20 0/19 0
huawei(config)#
interface vlanif 20
huawei(config-if-vlanif20)#
ip address 10.10.10.10 24
huawei(config-if-vlanif20)#
quit
Step 2
Configure the media and signaling IP address pools.
Add the IP address of the VLAN Layer 3 interface configured in the previous step to the media
and signaling IP address pools respectively, which facilitates the selection of media and signaling
IP addresses used for the services from the IP address pools. According to the data plan, IP
address 10.10.10.10 is added to the media and signaling IP address pools, and the gateway IP
address corresponding to the media IP address is 10.10.10.1.
huawei(config)#
voip
huawei(config-voip)#
ip address media 10.10.10.10 10.10.10.1
huawei(config-voip)#
ip address signaling 10.10.10.10
huawei(config-voip)#
quit
NOTE
l
You can configure the attributes of the H248 or MG interface only when the media IP address and the
signaling IP address exist in the media and signaling IP address pools.
l
The media IP address and the signaling IP address can be different. You can plan the IP addresses
according to the actual network.
Step 3
Add an MG interface.
Add an MG interface to communicate with the MGC, which ensures that the MGC can control
the call connection through the MG interface. According to the data plan, add MG interface 0,
and configure the interface attributes.
huawei(config)#
interface h248 0
Are you sure to add MG interface?(y/n)[n]:
y
huawei(config-if-h248-0)#
if-h248 attribute mg-media-ip1 10.10.10.10 mgip
10.10.10.10 mgport 2944 primary-mgc-ip1 10.10.20.20
primary-mgc-port 2944 code text transfer udp
Step 4
Configure the ringing mapping of MG interface 0.
Configure the user ringing mode. According to the data plan, the break-make ratios of the
cadence ringing and the initial ringing are both 1:4. Therefore, the value of parameter
cadence
is 0, and the value of parameter
initialring
is 4.
huawei(config-if-h248-0)#
mg-ringmode add 0 0 4
Step 5
Configure the TID format of PSTN users on MG interface 0.
Configure the TID generation mode. According to the data plan, the terminal prefix of PSTN
users needs to be
huawei
, and the TID template adopts layering template 6.
NOTICE
The MA5600T/MA5603T/MA5608T requires that the terminal prefixes of PSTN users, ISDN
BRA users, and ISDN PRA users on the same H.248 interface are either the same or different.
Note this when configuring the terminal prefix.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
3 Configuring the DSLAM Services
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
306
