huawei(config)#
interface gpon 0/1
huawei(config-if-gpon-0/1)#
pppoe simulate start
{ portid<U><0,7> }:
0
{ ontid<U><0,127> }:
1
{ eth<K>|untagged<K>|vlanid<U><0,4095> }:
eth
{ ont-portid<U><1,8> }:
4
{ untagged<K>|vlanid<U><0,4095> }:
100
{ priority<U><0,7>|user-name<K> }:
user-name
{ username<S><Length 1-64> }:
test@huawei
{ user-password<K> }:
user-password
{ password<S><Length 1-64> }:
test
{ authentication-mode<K> }:
authentication-mode
{ protocol<E><chap,pap> }:
chap
Command:
pppoe simulate start 0 1 eth 4 100 user-name test@huawei user-
password
test authentication-mode chap
huawei(config-if-gpon-0/1)#
----------------------------------
ONT PPPoE Test Result
----------------------------------
F/S/P : 0/1/0
ONT-ID : 1
ONT ETH Port ID : 4
ONT Vlan ID : 100
Vlan Priority : -
Emluator result : Success
Session ID : 18814
User IP : 192.168.100.101
Gateway IP : 192.168.100.1
----------------------------------
l
Troubleshooting methods for the Internet access service
1.
Check whether configurations are complete on the OLT.
–
Run the
display ont info
command to query the ONT status to check whether the
ONT is registered successfully.
–
Run the
display service-port
command to check whether the Internet access
service flow is configured and whether the inner VLAN ID of the service flow is
consistent with that in the data plan.
–
If a native VLAN is configured for the Ethernet port on the ONT, run the
display
ont port attribute
command in the xPON board mode to check whether the native
VLAN is correct.
2.
Check the upstream and downstream ports by checking the MAC address learning
status.
a.
Run the
display mac-address vlan
command to check the MAC address learning
status of the Internet service VLAN.
–
If the upstream port does not learn a MAC address, check the network
connections between the upstream port and upper-layer devices and check
the configurations of upper-layer devices.
–
If the downstream port does not learn a MAC address, check whether the
ONT is activated, whether the PC is connected to the right port on the ONT,
and whether the PC is working properly.
b.
Run the
display ont-learned-mac
command to check whether the ONT
connecting to the PON port learned any MAC addresses.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
9 FTTH Configuration
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
707
