l
Find an ONU automatically: If the password or SN of an ONU is unknown, run
the port ont-auto-find command in GPON mode to enable the ONU auto-find
function of the GPON port. Then run the
ont confirm
command to confirm the
ONU.
To add an ONU offline, do as follows:
huawei(config)#
interface gpon 0/3
huawei(config-if-gpon-0/3)#
ont add 1 1 sn-auth 48575443E6D8B541 snmp ont-
lineprofile-id
10 desc MA5631_0/3/1/1_lineprofile10
To automatically find an ONU, do as follows:
huawei(config)#
interface gpon 0/3
huawei(config-if-gpon-0/3)#
port 1 ont-auto-find enable
huawei(config-if-gpon-0/3)#
display ont autofind 1
//After this command is executed, the information about all the ONUs
connected to
//the GPON port using the optical splitter is displayed.
------------------------------------------------------------
Number : 1
F/S/P : 0/3/1
Ont SN : 48575443E6D8B541
Password :
VenderID : HWTC
Ont Version : MA5631
Ont SoftwareVersion : V800R310C00
Ont EquipmentID : SmartAX MA5631
Ont autofind time : 2011-09-10 11:20:16
------------------------------------------------------------
huawei(config-if-gpon-0/3)#
ont confirm 1 ontid 1 sn-auth 48575443E6D8B541
snmp ont-lineprofile-id
10 desc MA5631_0/3/1/1_lineprofile10
NOTE
If multiple ONUs of the same type are connected to a port and the same line profiles or service
profiles are bound to the ONUs, add these ONUs in batches by confirming the auto-found ONUs in
batches. The adding simplifies the operation and increases the configuration efficiency. Therefore,
the preceding command can be modified to: huawei(config-if-gpon-0/3)#
ont confirm 1 all sn-auth
snmp ont-lineprofile-id 10 desc MA5631_0/3/1_lineprofile10
.
5.
Confirm that the ONU goes online properly.
After an ONU is added, run the
display ont info
command to query the ONU status. Ensure
that
Control flag
of the ONU is
active
,
Run State
is
online
, and
Config state
is
normal
.
huawei(config-if-gpon-0/3)#
display ont info 1 1
---------------------------------------------------------------------
F/S/P :
0/3/1
ONT-ID :
1
Control flag : active //Indicates that the ONU is
activated.
Run state : online //Indicates that the ONU already goes online
properly.
Config state : normal //Indicates that the configuration status
of the ONU is normal.
...//The rest of the response information is omitted.
huawei(config-if-gpon-0/3)#
quit
If the ONU configuration fails or the ONU fails to be up, check the ONU state by referring
to the above-mentioned descriptions.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
18 OptiCable EoC Bandwidth Configuration
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1864
