1.
Add an MG interface.
Add an MG interface for the MG to communicate with the MGC, which ensures that the
MGC can control call connections through the MG interface. Add MG interface 0 according
to the data plan.
huawei(config)#
interface h248 0
Are you sure to add MG interface?(y/n)[n]:
y
2.
Configure MG interface attributes.
Configure MG interface attributes according to the data plan. When configuring the
attributes, note that:
l
The registration mode of the MG interface must be consistent with that on the MGC.
Registration mode: by IP address (default) or by domain name
l
H.248 version for negotiation: H.248v1, H.248v2, or H.248v3 (default). When H.248v3
is used, interfaces fail to be registered if some softswitches do not support H.248v3.
huawei(config-if-h248-0)#
if-h248 attribute mgip 10.10.10.10 mgport
2944 code text transfer udp primary-mgc-ip1 200.200.200.200 primary-mgc-port
2944 mg-media-ip1 10.10.10.10 start-negotiate-version 1
3.
Enable the MG interface.
huawei(config-if-h248-0)#
reset coldstart
Are you sure to reset MG interface?(y/n)[n]:
y
huawei(config-if-h248-0)#
quit
NOTE
l
After configuring the MG interface, you must perform a cold reset on the interface. Otherwise, the
interface cannot take effect.
l
You can perform a cold reset on the MG interface only after the following parameters are correctly
configured:
mgip
,
mgport
,
primary-mgc-ip1
(or
mgc-domain-name1
),
mgcport_1
,
code
,
transfer
, and
mg-media-ip
.
4.
Query the running status of the MG interface.
If the MG interface is interconnected with the MGC successfully, the MG interface is in
normal state which indicates that the interface is working properly.
huawei(config)#
display if-h248 all
-------------------------------------------------------------------------
MGID Trans State MGPort MGIP MGCPort MGCIP/DomainName
-------------------------------------------------------------------------
0 UDP
Normal
2944 10.10.10.10 2944 200.200.200.200
-------------------------------------------------------------------------
Step 5
Configure IUA links.
In the sigtran mode, configure the Signaling Transport protocol stack. Add an IUA link set first
and then add IUA links.
huawei(config)#
sigtran
huawei(config-sigtran)#
iua-linkset add 1 mgid 0 jointly-work enable trafficmode
override iid-map 2 cs-mode client
huawei(config-sigtran)#
iua-link add 0 1 1402 10.10.10.10 1404 200.200.200.200
jointly-work-with primary-mgc
huawei(config-sigtran)#
quit
Step 6
Add ISDN PRA user.
huawei(config)#
esl user
huawei(config-esl-user)#
mgprauser add 0 1 interfaceid 0 terminalid 512
----End
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
13 FTTO Configuration (Large-sized Enterprise Access)
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1321
