GSK 988T, Руководство пользователя

Страница: 305 / 416

Chapter
Ⅶ
Tool Offset and Setting Tools
291
Ⅱ
Operation
commanded measure position at the rapid traverse mode. And, the tool decelerates to stop at the
position which is Y from the measured position, and then, traverses to the measure position at the
measure speed set by No.6241
～
6243.
And then, after the tool approaches the distance ε , and when the measure position arrival signal
corresponding to the command is “1” in the course of the overtravel distance ε , the above
compensation amount is updated, and traverse command of the block ends. When the measure
position arrival signal has not become “1” from the measure position to the overtravel distance
ε ,
Fig. 7-10
Note 1: Refer
GSK988T Programming User Manual
about G36, G37;
Note 2: Refer to the user manual supplied by the machine manufacturer about the automatic toolsetting
device;
Note 3: No.6241: set X feedrate when automatic tool compensation;
No.6251: set Y value of X axis when automatic tool compensation;
No.6254: set
ε value of X axis when automatic tool compensation;
No.6242: set feedrate of Z axis when automatic tool compensation;
No.6252: set
γ value of Y axis when automatic tool compensation;
No.6255: set ε value of Z axis when automatic tool compensation;