GSK 988T, Руководство пользователя

Страница: 383 / 416

Appendix 1 Alarm List
369
Appendix
No. Message Contents
158
Depth of cut in G74 or G75
out of range Depth of cut in X or Z direction in G74 or G75 is out of
range. Modify the program.
160
,X or Z axis increment is 0 in
G76 X or Z axis increment is 0 in G76. Modify the program.
161
Repetitive count in finishing
is less than 1 or greater than
99 in G76 Repetitive count in finishing is less than 1 or greater than
99 in G76.\nModify the program.
162
Chamfering amount out of
range in G76 Angle of tool tip out of range in G76. Modify the
program.
163
Q( △ dmin) out of range in
G76
Minimum cutting depth Q( △ dmin) out of range in G76.
Modify the program.
164
In G76, Q( dmin) exceeds
△
the permitted range
Minimum cutting depth Q( △ dmin) out of range in G76.
Modify the program.
165
Finishing allowance R(d) out
of range in G76 Finishing allowance R(d) is less than least increment in
G76. Modify the program.
166
R and U is inconsistent for
taper thread cutting in G76 Machining start position is between thread beginning
point and end point in G76. Modify the program.
167
Thread height not specified
by P in G76 Thread height not specified by P in G76.\nModify the
program.
168
Thread height is less than
Finishing allowance or
minimum cutting depth in
G76 Thread height is less than Finishing allowance or
minimum cutting depth in G76. Modify the program.
169
Number followed address Q
is out of range in G76 Depth of cut in 1st cut Q was out of range, or not
specified. Modify the program.
180
Illegal S code command in
rigid tapping In rigid tapping, an S value is out of range or not
specified. Modify the program.
181
Illegal K in tapping Repetitive count, K, in rigid tapping is out of range.
Modify the program.
182
Illegal F in tapping Feedrate specified is out of range in tapping. Check
G98 & G99 modal. Modify the program.
183
Program miss at rigid
tapping Position for rigid M code and S command is incorrect in
rigid tapping. Modify the program.
184
Illegal axis operation in rigid
tapping In rigid tapping an axis movement is specified between
the rigid M code block and G84 block. Modify the
program.
185
The spindle of rigid taping is
not selected The spindle of rigid taping is not selected or the
specified axis cannot be used to tapping. Modify the
program.
186
Level changes while tapping Non G18 level was selected when tapping or start
tapping in non G18 level. Modify the program.
187
Incorrect data in tapping The specified distance is too short or long in tapping.
Modify the program.
188 Unusable data specified in Specify other M code or S code between rigid tapping