GSK 988T, Руководство пользователя

Страница: 281 / 416

Chapter
Ⅴ
Manual Operation
267
Ⅱ
Operation
O: Valid
×: Invalid
In increment mode, press feeding axis and on the machine panel, the
machine moves one step in the selected axial direction. The minimum distance which machine
moves is the minimum input increment, and each step can be 1 time, 10 times or 100 times of the
minimum input increment.
Increment feeding steps:
1. Press to select MPG mode;
2. Press to select the amount of movement of each step; moreover,
the distance of each step selected by is rewritten by parameter 7113 and 7114;
3. Press the feeding axis and , the machine moves along the selected axial
direction. Press the switch for one time, it moves for one step. Its feedrate is same as the manual
continuous feedrate.
4. Press rapid traverse switch when the feeding axis and the direction selection switches are on,
the machine moves at rapid traverse speed.
The rapid traverse override is valid during the rapid traverse.
Note: The minimum input unit (input) and the minimum command increment (output)are set by the 1
st
bit of
parameter #1004. The minimum input increment is the minimum unit of the programmed amount of
movement, the minimum command increment is the minimum unit of the tool traverse on the machine,
and the two increments are represented by millimeter or inch.
5.4 MPG Feeding
Press to access MPG mode, the appearance of MPG is shown as below:
MPG outside drawing
In MPG mode, the machine moves continuously through rotating MPG on the operational panel.