Extreme Networks ExtremeWare 7.7, Справочник по командам

Страница: 2002 / 2620

2002 ExtremeWare 7.7 Command Reference Guide
IP Multicast Commands
mode or sparse mode on a per-interface basis. After they are enabled, some interfaces can run dense
mode, while others run sparse mode.
PIM Dense Mode—“i” Series of Switches Only
Protocol Independent Multicast-Dense Mode (PIM-DM) is a multicast routing protocol that is similar to
DVMRP. PIM-DM routers perform reverse path multicasting (RPM). However, instead of exchanging its
own unicast route tables for the RPM algorithm, PIM-DM uses the existing unicast route table for the
reverse path. As a result, PIM-DM requires less system memory.
PIM-DM is a broadcast and prune protocol. Using PIM-DM, multicast routes are pruned and grafted in
a similar way as DVMRP.
PIM Sparse Mode (PIM-SM)
Unlike PIM-DM, PIM-SM is an explicit join and prune protocol, and it supports shared trees as well as
shortest path trees (SPTs). The routers must explicitly join the group(s) in which they are interested in
becoming a member, which is beneficial for large networks that have group members who are sparsely
distributed.
Using PIM-SM, the router sends a join message to the rendezvous point (RP). The RP is a central
multicast router that is responsible for receiving and distributing multicast packets. By default, the RP is
selected dynamically (but not automatically). You can also define a static RP in your network, using the
following command:
configure pim crp static <rp address> [none | <access profile>] {<priority [0-254]>}
When a router has a multicast packet to distribute, it encapsulates the packet in a unicast message and
sends it to the RP. The RP decapsulates the multicast packet and distributes it among all member
routers.
When a router determines that the multicast rate from of a particular group has exceeded a configured
threshold, that router can send an explicit join to the originating router. When this occurs, the receiving
router gets the multicast directly from the sending router, and bypasses the RP.
On the “e” series of switches, the switch cannot act as a candidate RP or as a candidate bootstrap router
(BSR).
NOTE
You can run either PIM-DM or PIM-SM per VLAN.
PIM Mode Interoperation—“i” Series of Switches Only
An Extreme Networks switch can function as a PIM multicast border router (PMBR). A PMBR
integrates PIM-SM and PIM-DM traffic.
When forwarding PIM-DM traffic into a PIM-SM network, the PMBR notifies the RP that the PIM-DM
network exists. The PMBR forwards PIM-DM multicast packets to the RP, which in turn forwards the
packets to those routers that have joined the multicast group.