Extreme Networks ExtremeWare 7.7, Справочник по командам

Страница: 1273 / 2620

show diagnostics packet-memory slot
ExtremeWare 7.7 Command Reference Guide 1273
show diagnostics packet-memory slot
show diagnostics packet-memory [msm-a | mem-b | mem-c | msm-d | <slot
number>]
Description
Displays the results of the packet memory scan on BlackDiamond 6808 and BlackDiamond 6816 I/O
modules or MSMs.
NOTE
This command is available only on the BlackDiamond switch.
Syntax Description
Default
N/A
Usage Guidelines
Use this command to display the results of a packet memory scan. The command output displays the
number of defects identified, and the number that were recoverable. If packet memory defects were
found, it displays information about each defect.
In ExtremeWare 6.2.1, this applies only to the G8Xi, G8Ti, G12SXi, and F48Ti. MSMs are not supported
in this release. In ExtremeWare 6.2.2, this apples to all “i”series modules and switches.
Example
The following command displays the results of a PM scan for slot 2, where a single defect was found:
show diagnostics packet-memory slot 2
If no defects are found, the output will look similar to the following:
------------------------------------------------------
Packet memory defect info for card 1
------------------------------------------------------
Num of defects = 0, num of recoverable defects = 0
------------------------------------------------------
If defects are found, the output displays the number of defects, and provides information about each
identified defect.
------------------------------------------------------
msm-a | msm-b |
msm-c | msm-d Specifies an MSM.
slot number Specifies the slot number of an I/O module.