Extreme Networks ExtremeWare 7.7, Справочник по командам

Страница: 1327 / 2620

configure wireless ports interface channel
ExtremeWare 7.7 Command Reference Guide 1327
configure wireless ports interface channel
configure wireless ports <portlist> interface [1 | 2] channel {0 |
<channel>}
Description
Configures a channel for the specified interface. With Dynamic Frequency Selection (DFS), the
command returns an error if RADAR interference is detected on the specified channel.
Syntax Description
Default
Auto for both interfaces
Usage Guidelines
Each wireless port on the Summit 300 contains two interfaces. Interface 1 supports 802.11a, and
interface 2 supports 802.11b/g radio signals. The
configure wireless port interface channel
command allows you to configure one of the two individual interfaces (1|2) on a port or ports. You can
move an interface from one profile to another without having to shut it down.
Valid channel values are shown in Table 23.
Example
The following command configures a channel for interface 2 on port 5 on a Summit 300-24:
configure wireless port 5 interface 2 channel auto
The following example shows command output if RADAR interference is detected on the specified
channel
# config wireless ports 15 interface 1 channel 44
Error: Interface 15:1 failed, please see log for details.
portlist Specifies one or more ports or slots and ports. Can be one or more port numbers. May be in the form
1, 2, 1:2, 3-5, 2:*, 2:5, 2:6-2:8.
interface Specifies an interface: 1 or 2.
0 Specifies that channels will be automatically selected. Enter ‘0’ (zero) to specify auto selection.
channel Specifies a particular channel. (See Table 23 for valid values.)
Table 23: Valid wireless interface channel values
WLAN Standard Valid Channels
802.11a 0 (auto), 36, 40, 44, 48, 52, 56, 60, 64, 149, 153, 157,
161, 165, 169, (34, 38, 42, 46 for Japan)
802.11b and 802.11g 0 (auto), 1-14 (Must be valid entry for the country code
range; e.g., valid range for USA is 1-11.)