Extreme Networks ExtremeWare 7.7, Справочник по командам

Страница: 783 / 2620

enable transceiver-test
ExtremeWare 7.7 Command Reference Guide 783
To display the transceiver test statistics, use the
show diagnostics sys-health-check
command. The
following is sample output:
Transceiver system health diag result
Pass/Fail Counters Are in HEX
Slot Cardtype Cardstate Test Pass Fail Time_last_fail
---- -------- --------- ---- -------- -------- --------------
slot 1 Unknown
slot 2 Unknown
slot 3 FM8V Operational MAC 2b81b 0
slot 4 GM4X Operational MAC 2b81b 0
BPLNE SMMI Operational UART 2b81a 0
BPLNE SMMI Operational FLASH 2b81a 0
BPLNE SMMI Operational SRAM 2b81a 0
BPLNE SMMI Operational NVRAM 2b81a 0
BPLNE SMMI Operational ENET 2b81a 0
BPLNE Basbrd Operational QUAKE 2b81a 0
BPLNE Basbrd Operational TWISTER 2b81a 0
For ExtremeWare 6.2.2b108:
The default for the transceiver test is enabled. The test is enabled two minutes after the switch boots or
immediately after you enable the test.
For ExtremeWare 6.2.2b134 and ExtremeWare 7.1.0:
The default for the transceiver test is disabled. If you load your saved ExtremeWare 6.2.2b108
configurations onto a switch with ExtremeWare 6.2.2b134 or ExtremeWare 7.1.0 or later, the transceiver
test is enabled. You must manually disable the transceiver test if you want the feature disabled.
Example
The following command enables the transceiver test on slot 4 of a modular switch:
enable transceiver-test slot 4
History
This command was first available in ExtremeWare 6.2.2b108.
The default for this command was changed to disabled in ExtremeWare 6.2.2b134.
This command was not supported in ExtremeWare 7.0.
This command is supported in ExtremeWare 7.1.0.
Platform Availability
This command is available only on modular switches.