Extreme Networks ExtremeWare 7.7, Справочник по командам

Страница: 1258 / 2620

1258 ExtremeWare 7.7 Command Reference Guide
Troubleshooting Commands
run diagnostics packet-memory slot
run diagnostics packet-memory slot [msm-a | msm-b | msm-c | msm-d | <slot
number>]
Description
Executes packet memory scanning for all packet memory associated with the specified MSM or I/O
slot.
NOTE
This command is available only on the BlackDiamond series switches.
Syntax Description
Default
N/A
Usage Guidelines
If you run the diagnostic routine on a module, that module is taken off-line while the diagnostic test is
performed. The ports on the module do not forward traffic. Once the diagnostic test is completed, the
module is automatically reset and becomes operational again.
NOTE
Run diagnostics when the switch can be brought off-line. The tests conducted are extensive and affect
traffic that must be processed by the system CPU. The diagnostics are processed by the CPU whether
you run them on an I/O or a management module.
Packet memory scanning scans the specified module to detect single bit-related memory defects and
their associated buffer locations. If packet memory defects are detected, their locations are recorded in
the module EEPROM. Up to eight occurrences can be recorded. If a defect was found during the scan
process, the module is reset, the defective buffer is mapped out from further use, and the module is
returned to the operational state. If more than eight defects are detected, or if the defects cannot be
mapped out, the module is treated as a failed module and left offline, unless
sys-health-check
is
configured for
online
. The module should then be returned through the RMA process with Extreme
Networks Technical Support.
When you enter the
run diagnostic
command, you are warned about any potential impacts on your
switch and network (since the module will be taken offline during the diagnostic process) and you will
have an opportunity to confirm or cancel the test.
To show the results of a packet-memory diagnostic, use the following command:
show diagnostics packet-memory slot <slot number>
msm-a | msm-b |
msm-c | msm-d Specifies the slot number of an MSM.
slot number Specifies the slot number of an I/O module.