Extreme Networks ExtremeWare 7.7, Справочник по командам

Страница: 1239 / 2620

configure diagnostics
ExtremeWare 7.7 Command Reference Guide 1239
configure diagnostics
configure diagnostics [extended | fastpost | normal | off | verbose |
quiet]
Description
Runs switch diagnostics at boot-up.
NOTE
This command is available only on the BlackDiamond 6804 and BlackDiamond 6808 switches.
Syntax Description
Default
Fastpost, quiet.
Usage Guidelines
To run diagnostics on an I/O module, use the following command:
run diagnostics [ cable | extended | normal packet-memory] slot [<slot> | msm-a |
msm-b | msm-c | msm-d]
The
cable
,
extended
, and
normal
modes are not supported on bootup at this time.
To view results of the diagnostics test, use the following command:
show diagnostics
Example
The following command configures the MSM to run the fastest diagnostics at boot-up:
configure diagnostics fastpost
extended Selects an extended diagnostic routine to run at boot-up. Takes the switch fabric and ports offline,
and performs extensive ASIC, ASIC-memory, packet switch, and packet loopback tests. This
parameter is not supported in ExtremeWare 6.1.9 or 6.2.
fastpost Selects fastpost diagnostic routine to run at boot-up. Takes the switch fabric offline and performs a
simple ASIC test.
normal Selects normal diagnostic routine to run at boot-up. Takes the switch fabric and ports offline, and
performs a simple ASIC and packet loopback test on all the ports. This parameter is not supported in
ExtremeWare 6.1.9 or 6.2.
off Stops boot-up diagnostics.
verbose Specifies that the results of every test are recorded in the log. The verbose option is not saved
through a reboot, so you must reconfigure verbose mode after running diagnostics.
quiet Specifies that only the pass or fail result is recorded in the log.