Extreme Networks ExtremeWare 7.7, Справочник по командам

Страница: 904 / 2620

904 ExtremeWare 7.7 Command Reference Guide
Security Commands
configure route-map add
configure route-map <route-map> add <seq_number> [permit | deny] {match-one
| match-all} {set lpm-routing | set iphost-routing}
Description
Adds an entry in the route map with the specified sequence number and action.
NOTE
This command is available only on the “i” series switches.
Syntax Description
Default
N/A
Usage Guidelines
The sequence number determines the order of the entry in the route map.
The action (permit or deny) specifies the action to be taken on a successful match against the statements
in the route map.
After an entry has been added to the route map, statements must be added to define the routes that
should be matched, using the
configure <route-map> add match
command.
This command can be used to override the VLAN LPM routing configuration for specific routes. The
set lpm-routing
and
set iphost-routing
keywords specify how packets are to be routed for
route-map matched IP prefixes. If the
lpm-routing
property is added to a route-map, packets are
forwarded to the IP prefixes’ next hop by the ARM/MPLS module using LPM routing.
If the
set iphost-routing
property is added to a route-map, packets are forwarded to the IP
prefixes’ next hop using the Inferno hardware host-based IP FDB. The
set lpm-routing
keyword is
significant only for routes learned on VLANs that are not LPM routing enabled. The
set
iphost-routing
keyword is significant only for routes learned on VLANs that are LPM routing
enabled.
route-map The name of the route map to which this entry should be added.
seq-number Specifies a sequence number that uniquely identifies the entry, and determines the position of
the entry in the route map.
permit Permits the route.
deny Denies the route. This is applied only if the match is successful.
match-one The route map is successful as long as at least one of the matching statements is true.
match-all The route map is successful only when all match statements are true. This is the default
setting.