Extreme Networks ExtremeWare 7.7, Справочник по командам

Страница: 2285 / 2620

configure aps force
ExtremeWare 7.7 Command Reference Guide 2285
configure aps force
configure aps <group#> force [off | working | protection]
Description
Requests that an APS group be forced to use a specified line as the active line.
Syntax Description
Default
The default is
force off
.
Usage Guidelines
You specify the
group#
parameter, which is an integer in the range [1-65535]. The
group#
identifies the
APS group that the force command applies to. When
force working
is specified, the command
requests that the APS group uses the working line as the active line. Conversely, when
force
protection
is specified, the command requests that the APS group uses the protection line as the active
line. A forced switch is a high priority request. Only three events can override a forced switch request:
(1) a
force off
command, (2) a
lockout on
command (that was either in effect before the force
command or issued after the force command), or (3) a signal-fail condition on the protection line. This
command is only applicable to SONET ports performing the protection line function. Additionally, the
effects of this command are not preserved across a switch reboot.
Example
The following command example forces APS group
1001
to use the protection line as the active line:
config aps 1001 force protection
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.5b20.
Platform Availability
This command is available on the BlackDiamond switch only.
group# Specifies the APS
group#
to which the command applies.
off Specifies that force is disabled.
working Specifies that the APS group uses the working line as the active line.
protection Specifies that the APS group uses the protection line as the active line.