Extreme Networks ExtremeWare 7.7, Справочник по командам

Страница: 721 / 2620

configure sys-health-check auto-recovery
ExtremeWare 7.7 Command Reference Guide 721
To view the failure messages, use the
show diagnostics
command.
To clear the MSM failure messages posted to the log, use the
clear log
command. This command
clears the error messages from the MSM NVRAM. If the MSM failed a system health check, this
command restores the MSM to full functionality. This command should only be used for additional
testing purposes and reproduction efforts of the original fault.
If you configure the system health check mode to
offline
and no new errors are detected, the device
scanned now remains on line. This behavior is identical to the current behavior if you use the
run
diagnostics
command.
Example
The following command configures the system health checker to try ten times to bring a faulty MSM
back on line:
configure sys-health-check auto-recovery 10
History
This command was first available in ExtremeWare 6.1.9.
The system health check functionality was modified in ExtremeWare 6.2.1 to support packet memory
defect detection and mapping on selected I/O modules.
This command was modified in ExtremeWare 6.2.2 to support system health check and checksum error
checking on the BlackDiamond 6804 switch and to add the
online
and
offline
parameters.
Platform Availability
This command is available on the BlackDiamond switch only.
The packet-memory defect detection and mapping feature is supported only on selected I/O modules.
See the release note for your version of ExtremeWare for information on the supported modules.