Extreme Networks ExtremeWare 7.7, Справочник по командам

Страница: 695 / 2620

configure log target filter
ExtremeWare 7.7 Command Reference Guide 695
The built-in filter DefaultFilter and a severity level of
info
are used for each new telnet session. These
values may be overridden on a per-session basis by using the
configure log target filter
command and specifying the target as
session
. Use the following form of the command for per-session
configuration changes:
configure log target session filter <filter name> {severity <severity> {only}}
Configuration changes to the current session target are in effect only for the duration of the session, and
are not saved in FLASH memory. The
session
option can also be used on the console display, if the
changes are desired to be temporary. If changes to the console-display are to be permanent (saved to
FLASH memory), use the following form of the command:
configure log target console-display filter <filter name> {severity <severity> {only}}
In versions prior to ExtremeWare 7.1.0, so-called
static
messages with a severity level of
warning
and
above were stored in NVRAM so they would be available across a reboot. This remains the default
behavior for ExtremeWare releases, but message filtering for the NVRAM target is now configurable.
Example
The following command sends log messages that pass the filter myFilter and are of severity
warning
and above to the previously configured syslog host at 10.31.8.25, port 8993, and facility
local3
:
configure log target syslog 10.31.8.25:8993 local3 filter myFilter severity warning
The following command sends log messages that pass the filter myFilter and are of severity
warning
and above to the current session:
configure log target session filter myFilter severity warning
History
This command was first available in ExtremeWare 7.1.0.
This command was added to the Summit “ e ” series of switches in ExtremeWare 7.2e.
Platform Availability
This command is available on all platforms.
Table 14: Default Target Log Characteristics
Target Enabled Severity Level Pre-7.1.0 Command to Set Log Severity
console display no info
configure log display {<severity>}
memory buffer yes debug-data N/A
NVRAM yes warning N/A
session no info N/A
syslog no debug-data
configure syslog add <host name/ip> {: <udp-port>}
[local0... local7] <severity>