Extreme Networks ExtremeWare 7.7, Справочник по командам

Страница: 773 / 2620

configure sys-hardware-recovery
ExtremeWare 7.7 Command Reference Guide 773
configure sys-hardware-recovery
configure sys-hardware-recovery [log | card-reset | card-offline|
system-offline | system-reset]
Description
Configures a recovery mechanism for a switch or module with a processor in a hang state.
NOTE
This command is available only on the “i” series switches.
Syntax Description
Default
The default is log.
Usage Guidelines
During multicast packet processing or broadcast storms, certain packet processor chips in the switch
that are involved with QoS and packet scheduling can enter a hang state and cannot independently
recover. This command enables dynamic monitoring of these packet processors using an optional active
polling mechanism and configures a hardware recovery mechanism for a system with such a hung
state.
Example
The following command sets the a BlackDiamond switch to reset an I/O module with a processor in a
hang state:
configure sys-hardware-recovery card-reset
log Posts a CRIT message to the syslog.
card-reset Shuts down an I/O module and brings it up again. After three resets, the I/O module is taken off
line and placed in a failed state.
Shuts down an MSM.
NOTE: This option is available only on BlackDiamond switches.
card-offline Shuts down all the ports on an I/O module and places the module in an offline state. The
system is still up and running and can access data registers on the module.
Shuts down an MSM.
NOTE: This option is available only on BlackDiamond switches.
system-offline Summit “i” series switches: Shuts down all ports in the system but leaves the system up and
running.
BlackDiamond and Alpine switches: Shuts down all ports and places them in an offline state.
Leaves the system up and running.
system-reset Resets the entire system.