Extreme Networks ExtremeWare 7.7, Справочник по командам

Страница: 1624 / 2620

1624 ExtremeWare 7.7 Command Reference Guide
STP Commands
show stpd
show stpd {<spanning tree name> | detail}
Description
Displays STPD settings on the switch. If an MSTP domain exists, the output includes the MSTP
configuration.
Syntax Description
Default
N/A
Usage Guidelines
The command displays the following STPD information:
• STPD name
• STPD state
• STPD mode of operation
• Rapid Root Failover
• Tag
• Ports
• Active VLANs
• Bridge Priority
• Bridge ID
• Designated root
• STPD configuration information
You can create, configure, and enable one or more STP domains and use the
show stpd
command to
display STP configurations. Use the
create stpd
command to create an STP domain. Use the
enable
stpd
command to enable an STPD. If you have considerable knowledge and experience with STP, you
can configure the STPD using the
configure stpd
commands. However, the default STP parameters
are adequate for most networks.
Examples
The following command displays global STPD settings for a system with MSTP configured:
show stpd
spanning tree name Specifies an STPD on the switch.
NOTE: This option is available only on the “i” series switches.
detail Specifies that STPD settings should be shown for each STPD.
NOTE: This option is available only on the “i” series switches.
domain Specifies an STPD on the switch. Supported on e platform switches.